Radar Roy and his staff began the project by first installing the Blinder M-20 laser jammer.

The Blinder M-20 comes with two laser jammer heads. As a laser beam is 18" wide at 500 feet, one jammer to the front, near the R1's headlamp, and one laser jammer head in the rear, near the license plate, would be adequate to jam all police laser guns.

The rear head was installed first using a mount fabricated by "Spider Mounts" who are Radar Roy's fabricators and who manufacture many of the specialized motorcycle radar detector mounts sold on RadarBusters. This mount connected the rear jammer to the license plate of the R1.

Rear Blinder Jammer

The front Blinder jammer head was installed under the front faring using double sided tape.

Blinder Laser Jammer head in front

The controller for the Blinder must be installed in a water proof area. The Blinder jammer heads, the power cable, the alert LED and Speaker all plug into the controller using standard RJ-11 jacks. (telephone jack). It was determined that the best location for the controller would be under the seat.

Blinder Controller under seat of R1

The Blinder has an LED and small speaker to alert when the laser jammer is activated. The LED was mounted using nylon "Zip Ties" to the ignition switch. The speaker (app 3") was taped to the faring using double sided tape.

LED Light Activated "RED"

The power switch was mounted to the side of the seat, allowing the rider to power on or off the Blinder M-20 while riding.

Power Switch mounted at seat

The install of the Blinder M-20 on the R1 motorcycle took approximately two hours.

>> Next